Initial vol level, Maximum vol level, Input lock – Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display User Manual
Page 78: Button lock, Controller user level
English
78
Initial VOL level
Adjusts the sound volume level when the unit is turned
on.
[Off]:
It will be the sound volume level which had been set
before the power of the unit was turned off.
[On]:
Sets your preferred volume.
●
Outputs with the set volume when [Initial VOL level] in
[On] state is selected on the menu.
■
To adjust sound volume level
Press
Note
●
When [Maximum VOL level] is [On], the volume
cannot be set to the level higher than the level set for
[Maximum VOL level].
Maximum VOL level
Adjusts the maximum volume.
[Off]:
The sound volume level can be set up to 100
(maximum).
[On]:
The sound volume level will not exceed the set
point.
●
Outputs with the set volume when [Maximum VOL
level] in [On] state is selected on the menu.
■
To adjust sound volume level
Press
Note
●
When the [Maximum VOL level] is switched from
[Off] to [On], if the [Maximum VOL level] is set lower
than the [Initial VOL level], the [Initial VOL level]
automatically becomes the same as the [Maximum
VOL level].
Input lock
Locks the input switch operation.
[Off] / [HDMI] / [DisplayPort] / [DIGITAL LINK] /
[DVI-D1] / [DVI-D2] / [PC] / [USB]
Note
●
Input switch can be used when this is set to [Off].
Button lock
Limits operation of the buttons on the unit.
[Off]:
All the buttons on main unit can be used.
[On]:
All button operations except for the (Unit)> are disabled. [MENU & ENTER]: Locks
■
To set [Button lock]
Set with the buttons on the unit.
[Off]:
Press <+ (Unit)> for 4 times.
Press for 4 times.
Press <- (Unit)> for 4 times.
Press
[On]:
Press <- (Unit)> for 4 times.
Press
Press <+ (Unit)> for 4 times.
Press
[MENU & ENTER]:
Press
Press <+ (Unit)> for 4 times.
Press for 4 times.
Press
Note
●
About how to reset the settings to defaults:
“Initialization” (see page 81)
Controller user level
Limits operation of the buttons on the remote control.
[Off]:
You can use all of the buttons on the remote control.
[User1]:
You can only use
,
[User2]:
You can only use
buttons on the remote control.
[User3]:
Locks all the buttons on the remote control.
Note
●
About how to reset the settings to defaults:
“Initialization” (see page 81)