Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 53)

53
English
■
Input signal display
Displays the frequency and the type of the current input
signal.
60.00 Hz
74.18 MHz
1125(1080)/60i
33.72 kHz H-freq.
V-freq.
Dot clock freq.
Signal format
Display range:
Horizontal (15 kHz - 135 kHz)
Vertical (24 Hz - 120 Hz)
The dot clock frequency is displayed when Digital and
PC signal are input.
Control settings
Sets each item of the function which enables to control
multiple displays at the same time, or individually.
[Control settings] - submenu screen
0
Control settings
IR control
IR out
Serial ID group
Serial control
Serial response(ID group)
Serial response(ID all)
Serial daisy chain position
IR OUT
A
SERIAL IN
Off
Off
Multi control auto setting(DIGITAL LINK)
Serial out SERIAL OUT
Display ID
Controller ID function
Off
Serial ID function Off
Serial response (Normal) On
Built-in
■
[IR control]
Sets the terminal used for the IR signal input.
The terminal ([Built-in] / [IR IN] / [DIGITAL LINK])
which is currently selected is displayed on the [Control
settings] submenu screen.
Select [IR control] with and press .
On the [IR control] submenu screen, select the terminal
to use.
IR control
IR control Auto
[IR IN]:
Connecting an external IR receiver or IR cable to
the IR IN terminal will switch to the remote-control
operation via the IR IN terminal. The display is
fixed to [IR IN].
Although the setting can be changed to something
other than [IR IN] while using the IR IN terminal,
the changed setting is invalid.
[Auto]:
Only when connected to the unit via DIGITAL
LINK, signals are received with the DIGITAL LINK
IN terminal. For other connections, remote control
signals are received with the remote control sensor
of the unit.
[Built-in]:
Remote control sensor of the unit
[DIGITAL LINK]:
DIGITAL LINK IN terminal
Note
● [IR IN] cannot be set manually.
● When [Auto] is set, the unit automatically detects the
connection in power-on status. This setting does not
respond to the connection change in standby mode.
● The changed setting is enabled when the [IR control]
sub menu screen is exited.