Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 106)

English
106
Using data cloning
Menu settings and adjusted values of a single display
can be copied to multiple displays by using a USB
memory or via LAN.
Note
● If the sizes of the displays are different, the cloning
function does not operate. Use the common sized
displays.
● Set the input to something other than [USB], and
perform the data cloning.
● The cloning password is the one set for [Cloning
password].
● The initial password in the factory default state is
[AAAA].
● The remote control is necessary to operate [LAN data
cloning].
■
Data that can be copied
Settings and set values of [Picture], [Sound], [Setup],
[Position] and [Options] menus
User image registered in [Setup] - [Startup image
settings]
The following contents of the [Detailed set up] page
on the Web control screen
[Status notification set up]
● The following data cannot be copied. Setting is
required for each display.
[Cloning password]
[Date and time]
[Network settings] - [Display name]
Setting for [Network settings] - [LAN setup]
Display ID in [Control settings]
Setting for [Signal] - [Multi dynamic backlight
settings]
Setting for [Options] - [Long life settings]
The setting contents of the [Change password]
page on the Web control screen
The following contents of the [Detailed set up]
page on the Web control screen
[Network config]
[Adjust clock]
[Command port set up]
The setting contents of the [Crestron Connected]
page on the Web control screen
■
Supported device
● Commercially available USB memory devices
are supported. (Those with security functions are
not supported.)
● USB memory devices other than those formatted
in FAT16 or FAT32 cannot be used.
● Up to 32 GB of USB memory in size are
supported.
● Only single partition configuration is supported.
Note
● Set the input to something other than [USB], and
perform the data cloning.
● [USB data cloning] can also be displayed using the
main unit buttons.
Operate in the same way as described in “Options
Adjustments” - “Unit” (see page 76).
● The remote control is necessary to operate [LAN
data cloning].