Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 69)

69
English
Network settings
Set when networking with a computer.
[Network settings] submenu will be displayed.
Network settings
Network control
VF2H-000
Off
Off
Off
Off
Display name
DIGITAL LINK status
DIGITAL LINK menu
Network status
LAN setup
AMX D. D.
Extron XTP
Crestron Connected™
Reset
On Auto display name
Permit USB memory network settings
DIGITAL LINK mode Auto
■
[Network control]
Set when controlling with the unit’s LAN terminal.
[On]:
Controls via LAN using the LAN terminal of the
Display. The power indicator lights orange when
the power is turned off with the remote control
(standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
● When using the LAN control function for “Using
Network Function” (see page 82 - 97), set this
function to [On].
● The operations of the main software version
1.2000 or later are as follows.
• To enable the operation, set [Quick start] to
[On].
• When [Quick start] is set to [Off], the power
can be turned off via network control even
if [Network control] is set to [On]. However,
the power cannot be turned on from standby
state. To control both, it is necessary to set
both [Quick start] and [Network control] to [On]
respectively.
■
[Auto display name]
Sets whether to change the display name
automatically.
[On]:
Changes the display name automatically in
accordance with the set point of the display ID.
[Off]:
The display name is not changed automatically.
■
[Display name]
The name of the Display that is shown on the network
can be changed.
Note
● The name can be changed only when [Auto display
name] is set to [Off].
● Display ID is not reset to default with [Network
settings] - [Reset].
■
[LAN setup]
Detailed network settings for the LAN established via the
LAN terminal of the Display can be configured.
Select [LAN setup] with and press .
192.168. 0. 8
255.255.255. 0
192.168. 0. 1
1024
--:--:--:--:--:--
LAN setup
Save
DHCP Off
IP address
Subnet mask
Gateway
Port
MAC address
[DHCP] / [IP address] / [Subnet mask] / [Gateway]
Set [On] / [Off] of [DHCP] with .
When [Off] is selected, IP address and other settings
can be set manually.
[DHCP]:
(DHCP client function)
[On]:
Obtains an IP address automatically when a
DHCP server exists in the network the Display is
going to be connected.
[Off]:
When a DHCP server does not exist in the
network the Display is going to be connected,
set [IP address], [Subnet mask] and [Gateway]
manually.
[IP address]:
(IP address display and setting)
Enter an IP address when DHCP server is not used.
[Subnet mask]:
(Subnet mask display and setting)
Enter a Subnet mask when DHCP server is not
used.