Panasonic TH-55VF2HW 54.6" Full HD Video Wall Display - Manual (Page 33)

33
English
Basic Controls
Remote Control Sensor
/ Power Indicator
(Back of the unit)
Main power switch
( / )
(Back of the unit)
AC socket outlet
AC cord (supplied)
Operate pointing the remote control directly at
the unit’s Remote Control Sensor.
Note
● Do not put an obstacle between the remote control
sensor of the main unit and the remote control.
● Do not subject the remote control sensor of the main
unit to the direct sunlight or strong fluorescent light.
1 Connect the AC cord plug to the
Display.
(see page 18)
2 Connect the plug to the socket outlet.
Note
● Main plug types vary between countries. The power
plug shown at left may, therefore, not be the type
fitted to your set.
● When disconnecting the AC cord, be absolutely sure
to disconnect the AC cord plug at the socket outlet
first.
● The settings may not be saved if the power plug is
disconnected or the display is turned off at the
power switch> immediately after changing settings
with on-screen menu. Leave enough period of time
before disconnecting the power plug or switching the
display off at the
power off with the remote control, RS-232C control or
LAN control before disconnecting the power plug or
switching the display off at the
3 Switch the
( / ) ON ( ).
■
To turn the power ON/OFF with the remote
control or :
To turn the power ON
The picture is displayed by pressing or
when the
ON ( ) (Power Indicator: Red or orange).
● Power Indicator: Green (Picture is displayed.)
To turn the power OFF
The power is turned OFF (Standby) by pressing
or when the
power switch> is ON ( ) (Power Indicator: Green).
● Power Indicator: Red or orange (standby)
When the power is ON (Picture is displayed.) or OFF
(standby), the power of the display is turned OFF by
switching the
Note
● During operation of the “Power management” function
(see page 65), the power indicator turns orange in the
power off state.