Panasonic TH-86EQ2W 85.6" 4K Digital Signage Display - Manual (Page 158)

158
English
Copying the display data to the USB
memory
1 Insert the USB memory device to
the USB terminal on the side of the
display.
USB memory
USB terminal
Note
● Depending on the type of a USB memory device,
it may come in contact with the periphery such as
a back cover, and cannot be attached. Use a USB
memory device connectable to this unit.
● Failure to save in or read from the USB memory
device displays an error message.
2 After the [Cloning password] screen
is displayed, go to the step 6 .
When the [Cloning password] screen is not
displayed, follow the steps 3 to 5 to display.
3 Display [Setup] menu pressing
.
4 Select [Options] with and press
.
The following display appears.
Display information
Options
Software licenses
Cloning password
USB data cloning
Security password
LAN data cloning
Output log data
Shipping
5 Select [USB data cloning] with
and press .
[Cloning password] screen is displayed.
6 Enter the cloning password, and then
press .
Data cloning screen is displayed.
7 Select [ Display → USB memory ] with
and press .
Select copy type
Display → USB memory
USB memory → Display
8 Select [Yes] with and press
.
Data copy to the USB memory starts.
Data to USB memory
The data will be overwritten when any data
exists originally. Are you OK to write the data ?
Yes No
The following message is displayed after data copy
has finished.
Data copy finished.
9 After data copy has finished, remove
the USB memory device from the USB
terminal.
Copying (cloning) the USB memory
data to the display
1 Insert the USB memory device, which
the data has been copied, to the USB
terminal of the display for data copy
(same as the step 1 on page 158).
2 After the [Cloning password] screen
is displayed, go to the step 6 .
When the [Cloning password] screen is not
displayed, follow the steps 3 to 5 to display.
Note
● If the USB memory containing the data for cloning
is connected in power-on state, the [Cloning
password] screen is displayed.
3 Display [Setup] menu pressing
.
4 Select [Options] with and press
.
The following display appears.
Display information
Options
Software licenses
Cloning password
USB data cloning
Security password
LAN data cloning
Output log data
Shipping
5 Select [USB data cloning] with
and press .
[Cloning password] screen is displayed.