ProSoft Technology 5201-DFNT-104C - Manual (Page 115)

104C Version 3 ♦ ProLinx Gateway Reference
IEC 60870-5-104 Client (Firmware v3.xx) Protocol Manual
ProSoft Technology, Inc. Page 115 of 139
August 4, 2011
OFFSET PARAMETER DESCRIPTION
0 Active Active status of client
0 = not active
1 = waiting on StartDT con
2 = Online (StartDT con received)
1 State State of Client Socket:
-255 = Idle until processor in run
-1 = Ready for socket open
0 = Waiting for socket establish
1 = Read and write data to socket (process data)
70 = Sending StartDT act
80 = Sending StopDT act
100 = End program/close socket
1000 = Close socket (start 2-second timeout)
1001 = Wait for close & abort if timeout
2000 = ARP request/response
2001 = Open Socket
2 Open Count Number of times socket open attempted
3 Close Count Number of times socket closed
4 Connect Count Number of times socket established
5-14 Host IP ASCII string of remote server IP address (10 words)
15 t0 Timeouts Number of t0 timeouts
16 t1 Timeouts Number of t1 timeouts
17 t2 Timeouts Number of t2 timeouts
18 t3 Timeouts Number of t3 timeouts
19 Sequence Errors Number of sequence errors
20 Bad Address
Errors Number of bad address errors
21 Length Errors Number of length errors
22 Rx Frame Count Number of frames received on socket
23 Tx Frame Count Number of frames transmitted on socket
24 Cmd Requests Number of commands issued from command list and queue
25 Cmd Responses Number of responses to commands issued from command list and
queue.
26 Cmd Error Count Number of errors recognized when issued from command list or
queue
27 Requests Number of requests from command driver
28 Responses Number of messages received by command driver
29 Errors Sent Number of errors sent by command driver (not used)
30 Errors Received Number of errors received by command driver
31 Configuration
Error Configuration error word for client
32 Current Error Current error recognized
33 Last Error Last error recognized
34 Send Number Send sequence number