PLANET MGSW-28240F - Manual (Page 349)

User’s Manual of MGSW-28240F
The page includes the following fields:
Object Description
The logical port for the settings.  Port
The destination IP Address. 
Remote IP Address
The payload size of the ICMP packet. Values range from 8 bytes to 1400 bytes. 
Ping Size
Display the ping result. 
Result
Buttons
: Click to start ping process.
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
: Clears the local counters. All counters (including global counters) are cleared upon reboot.
4.15.4 Cable Diagnostics
This page is used for running the Cable Diagnostics.
Press to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this can take approximately 15
seconds. When completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status
table. Note that Cable Diagnostics is only accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports will be linked down while running cable diagnostic. Therefore, running cable diagnastic on a 10 or 100
Mbps management port will cause the switch to stop responding until VeriPHY is complete. The ports belong to the currently
selected stack unit, as reflected by the page header. The VeriPHY Cable Diagnostics screen in Figure 4-15-4 appears.
Figure 4-15-4: VeriPHY Cable Diagnostics Page Screenshot
349