PLANET MGSW-28240F - Manual (Page 222)

User’s Manual of MGSW-28240F
4.9.11 QoS Control List
This page shows the QoS Control List (QCL), which is made up of the QCEs. Each row describes a QCE that is defined. The
maximum number of QCEs is 256 on each switch.
Click on the lowest plus sign to add a new QCE to the list.
The QoS Control List screen in Figure 4-9-13 appears.
Figure 4-9-13: QoS Control List Configuration Page Screenshot
The page includes the following fields:
Object Description
Indicates the index of QCE. 
QCE#
Indicates the list of ports configured with the QCE.  Port
 Frame Type Indicates the type of frame to look for incomming frames. Possible frame types
are:

Any : The QCE will match all frame type.

Ethernet : Only Ethernet frames (with Ether Type 0x600-0xFFFF) are
allowed.

LLC : Only (LLC) frames are allowed.

SNAP : Only (SNAP) frames are allowed.

IPv4 : The QCE will match only IPV4 frames.

IPv6 : The QCE will match only IPV6 frames.
Displays the OUI field of Source MAC address, i.e. first three octet (byte) of MAC
address.
 SMAC
 DMAC Specify the type of Destination MAC addresses for incoming frame. Possible
values are:

Any : All types of Destination MAC addresses are allowed.

Unicast : Only Unicast MAC addresses are allowed.

Multicast : Only Multicast MAC addresses are allowed.

Broadcast : Only Broadcast MAC addresses are allowedd.
The default value is 'Any'.
Indicates (VLAN ID), either a specific VID or range of VIDs. VID can be in the
range 1-4095 or 'Any'
 VID
 PCP Priority Code Point: Valid value PCP are specific(0, 1, 2, 3, 4, 5, 6, 7) or
range(0-1, 2-3, 4-5, 6-7, 0-3, 4-7) or 'Any'.
222