PLANET MGSW-28240F User Manual

Page 143

User’s Manual of MGSW-28240F



Tagged packet entering VLAN 2

While [PC-3] transmits a tagged packet with VLAN Tag=2 enters Port-3, [PC-1] and [PC-2] will receive the packet

through Port-1 and Port-2.

While the packet leaves Port-1 and Port-2, it will be stripped away it tag becoming an untagged packet.



Untagged packet entering VLAN 3

1. While

[PC-4]

transmits an untagged packet enters Port-4, the switch will tag it with a VLAN Tag=3. [PC-5] and

[PC-6]

will receive the packet through Port-5 and Port-6.

While the packet leaves Port-5, it will be stripped away it tag becoming an untagged packet.

While the packet leaves Port-6, it will keep as a tagged packet with VLAN Tag=3.

For this example, VLAN Group 1 is set as default VLAN, but only focuses on VLAN 2 and VLAN 3

traffic flow. The example screenshot comes from the other switch but the configuration interface is the

same with MGSW-28240F.

Setup steps

1. Create

VLAN

Group

Set VLAN Group 1 = Default-VLAN with VID (VLAN ID) =1

Add two VLANs – VLAN 2 and VLAN 3

VLAN Group 2 with VID=2

VLAN Group 3 with VID=3

2. Assign VLAN Member :

VLAN 2 : Port-1,Port-2 and Port-3

VLAN 3 : Port-4, Port-5 and Port-6

VLAN 1 : All other ports – Port-7~Port-24

3. Remove VLAN Member for VLAN 1:

Remember to remove the Port 1 – Port 6 from VLAN 1 membership, since the Port 1 – Port 6 have to be assigned to

VLAN 2 and VLAN 3.

Figure 4-6-9:

Add new VLAN group, assign VLAN members for VLAN 2 and VLAN 3 and remove specified ports from VLAN 1

member

143