TA Triumph-Adler DC 2316 - Manual (Page 63)

System Settings
OPERATION GUIDE 8-3
1
Access 17. Drum Reset.
If you are unsure how to use this route map refer to Accessing Menu Items on
page xx.
2
Press W or X to select On and press [OK]. The display returns to the ready
screen.
Drum Refresh
The drum refresh is cleaning the drum surface. If potential printing quality problems
has occurred, perform the drum refresh. Refer to General Guidelines on page 10-1.
1
Access 18. DrumRefresh.
If you are unsure how to use this route map refer to Accessing Menu Items on
page xx.
2
Press W or X to select On or Off. Press [OK]. The display returns to the ready
screen.
Drum Control
The drum control is cleaning the drum surface automatically when the machine is
turned on. You can adjust the cleaning time from 0, 90, 155 seconds.
1
Access 19. DrumControl.
If you are unsure how to use this route map refer to Accessing Menu Items on
page xx.
2
Press W or X to select the cleaning time. Press [OK]. The display returns to
the ready screen.
Eco Fuser
When this mode is selected On, the fuser heater is switched off during sleep mode
to save power consumption. However, warm-up time becomes longer than Off.
[Menu]
W or X
1. Common Setup
[OK]
W or X
17. Drum Reset
[OK]
[Menu]
W or X
1. Common Setup
[OK]
W or X
18. DrumRefresh
[OK]
[Menu]
W or X
1. Common Setup
[OK]
W or X
19. DrumControl
[OK]