Eicon Networks DIVA T/A ISDN - Manual (Page 31)

DIVA T/A ISDN Modem User’s Guide
◆ Page 31
Setup for Other Operating Systems
The DIVA T/A does not include native installation applications for Windows 3.x, Windows for
Workgroups 3.11, DOS, OS/2, Macintosh (prior to System 7), and other operating systems.
However, it is still possible to configure the DIV AT/A using the VT100 Configuration Tool. A
VT100-compatible terminal emulation program is required.
Windows 3.x and Windows for Workgroups 3.11
If you are going to use the DIVA T/A with RAS for WFW, RAS must already be installed with at
least one modem. Any modem will do; it is only needed to properly install the DIVA T/A and
will later be removed.
If you are using RAS, follow the steps below. If you do not want to use RAS, see “The VT100
Configuration Tool” on page 73.
1 Connect the cables to your DIVA T/A as outlined on page 7.
2 Power on your PC.
3 Insert the DIV AT/A CD into your computer's CD drive.
4 With any text editor, open the file MODEM.INF found in the Windows\System directory.
5 Open the file WFWNTEI2.INF (found at the root of the DIV AT/A CD).
6 Copy the contents of WFWNTEI2.INF to the end of the MODEM.INF file; save the
appended MODEM.INF file, and exit your text editor.
7 Start the RAS setup program.
8 From the RAS setup, change the unused modem to the DIVA T/A. Refer to the RAS online
help to change modems.
9 To set your ISDN parameters, follow the instructions provided in “The VT100
Configuration Tool” on page 73.
DOS, OS/2, Macintosh (prior to System 7), and Others
1 Connect the cables to your DIVA T/A as outlined on page 7.
2 Power on your PC.
3 To set your ISDN parameters, follow the instructions provided in “The VT100
Configuration Tool” on page 73.