Ut 01 day5, Ut 01 63°c – MCZ Athos HYDRO 14 kW User Manual
Page 44
PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
44
Operation
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
SET
TURBO
1
2
6
4
3
5
!
Ut 01
day5
Press twice more on button
n
and you will see in sequence the
messages “DAY 6
→ DAY 5”.
The display (8) will now show the message “DAY 5” alternating with
the code
“UT 01”.
The same procedure can be implemented using the button
o
. The only
difference is that the menu scrolls in the opposite direction as shown:
“OFF
→DAY 1→DAY 2→DAY 3→DAY 4→DAY 5”
To memorize the setting, press the button
p
.
SUMMARY:
To ACTIVATE the PROGRAMMED mode (indicator light 9 on) press in
sequence the buttons
o
and
p
to show the code
“UT 01”. Then press
the buttons
n
or
o
to increase or decrease the start day. To
memorize, press the button
p
.
ATTENTION!
Any day memorized except for the message “OFF”
activates PROGRAMMED mode.
To DE-ACTIVATE PROGRAMMED mode (indicator light 9 off), press in
sequence buttons
o
and
p
to display the code “UT 01”. Then press
the buttons
n
or
o
until the message “OFF” is shown; confirm by
pressing the button
p
.
Only the memorized message “OFF” de-activates the
PROGRAMMED mode.
4.10.4.2.
Clock (code on display UT 02 and UT 03)
See paragraph 4.5.1. on time setting to find out how to set the current
time.
The following are the main points.
•
Setting of HOURS (code on display UT 02)
Press the buttons
o
and
p
to access the setting menu and
parameter “UT 01”. Use the button
p
to access the parameter
“UT02” which corresponds to the time on the clock expressed in
HOURS.
The display (8) will alternately show the code “UT 02” and the
indication of the internal time of the stove present at that moment.
Use the button
n
(increase) or
o
(decrease) to set the hours.
To memorize, press the button
p
, which will take you to the next
display, “UT 03”, to set the minutes.
•
Setting of MINUTES (code on display UT 03)
The display (8) will alternately show the code “UT 03” and the
current minutes on the clock.
Use the button
n
(increase) or
o
(decrease) to set the minutes.
To memorize, press the button
p
. This will take you to the display
of “UT 04”.
Buttons for menu access.
Selection of current day and activation of
programmed mode.
SET
TURBO
1
2
6
4
3
5
!
Ut 01
63°C