R ic, Ric n c2, N c4 r ic – MCZ Athos HYDRO 14 kW User Manual
Page 36: Procedure for recipe selection
PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
36
Operation
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
SET
TURBO
1
2
6
4
3
5
!
- - - -
r ic
4.6.1.1. Identification of type of pellet
To identify the type of fuel:
Requirements:
•
Scales (measuring up to ½ kg) with graduations down to 10 g
•
MCZ pellet measuring container supplied with stove (PelletBox®)
•
A batten
•
Pellets (fuel)
Fill the PelletBox® generously with pellets without compacting it
(i.e. without banging the measure on the table or pressing the pellets
down with the hands).
Figure 1
Rest the batten (or ruler, blade or pencil) on the top edge of the
container and level the material by removing the excess.
Figure 2
Weigh the total (container + pellets) and note the weight.
Figure 3
Take the measure, empty it, and look at the table designed for the
selection of the recipe.
Figure 4
4.6.2. Procedure for recipe selection
In the left-hand column, marked 'Weight', identify which row contains
the weight which was noted earlier.
On the same line, identify in the right-hand column of the table the
correct parameter (recipe) for your fuel.
Example:
Suppose you are using fuel that weighs 680 grams.
First of all, identify the model of stove in question (in the example, a
Polar Hydro). Then look at the corresponding table on the face of the
measuring cup. In the “Weight” column, you will see that 680 g is
included in the line “from 660 to 700”.
Moving to the column alongside the one for weight, you will see that
the recipe to be used to programme the stove is C2.
4.6.3. Memorization of recipe on stove.
THE PROCEDURE FOR SELECTING THE RECIPE IS
ACTIVE ONLY WHEN THE STOVE IS NOT LIT.
Press in rapid succession, or simultaneously, the buttons
p
and
q
.
The message "ric" will appear, alternating with the number of the
previously set recipe (to recall the previous example, “n C2” will be
shown).
Alternatively, if the display shows the message "- - - -", it indicates that
no recipe is currently selected (first lighting).
To exit from the menu without making changes, press key
p
or key
q
, or wait 120 seconds without pressing a key.
To modify or set a new recipe, press the buttons
n
or
o
in order to
find the desired recipe according to the diagram on the BoxPellet®
(measuring cup). The diagram is reproduced here.
Phase 1: Example of access to recipe menu
and display of previous setting
Phase 2: To choose the desired recipe, press
the indicated button
First access to recipe selection menu
Figure 1
Figure 2
Figure 3
Figure 4
PelletBox®
PelletBox®
SET
TURBO
1
2
6
4
3
5
!
n C4
r ic
SET
TURBO
1
2
6
4
3
5
!
RIC
n C2