17°c 63°c, Programmed mode (with timer) – MCZ Athos HYDRO 14 kW User Manual
Page 43
PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
43
Operation
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
STOVE BEHAVIOUR WITH TIME ACTIVE:
Stove status
Timer intervenes
to…
The stove…
ECO STOP
Shut down the stove
Shuts down permanently
and turns OFF
ECO STOP
Light the stove
Remains in ECO STOP
status
4.10.3.1.
Activation /de-activation of ECO-STOP mode
4.10.3.2. OPERATION TO BE CARRIED OUT BY THE INSTALLER
•
Press the main switch on the back of the stove and place it in the
position “I”. The display of the control panel will show the message
OFF/CURRENT TIME
•
Press the button
o
immediately followed by the button
p
on the
control panel. The display of the control panel will show the
message UT01/OFF
•
Press the button
p
repeatedly until the display on the panel shows
“
UT16"; the display of the control panel shows UT16/OFF
•
Press and hold the button
q
and then press the button
p
and go
to item
“UT19”; the display will show the message UT19/OFF
•
Press the button
n
or
o
to activate or deactivate the function, or
to change the time of intervention of the ECO-STOP mode. The
display of the panel will show the message UT19/OFF or UT19/1’,
UT19/2’, UT19/3’………. UT19/30’
•
Press the button
r
for a few seconds to confirm until the panel
shows the message OFF/CURRENT TIME
4.10.4. Programmed mode (with timer)
This operating mode, shown by the indicator light (9) on the display,
lets you programme stove lighting or extinguishing on a weekly basis.
Normally, the POLAR and NOVA stoves have the PROGRAMMED
mode deactivated. (indicator light 9 is off)
The basic characteristics in PROGRAMMED mode are:
•
Start day
•
Clock
•
Programme (4 daily programmes are available)
4.10.4.1.
Start day (code on display UT 01)
The current day is set first, and will act as a reference for the
programming sequence. This means you will need to ask yourself: what
day is it today?
Suppose that as you read this paragraph it is Friday. Using the table
shown here (
Figure 8), you will see that Friday corresponds to DAY 5.
You will need to assign the stove the starting day of DAY 5.
To set this value, press in sequence buttons
o
and
p
. The code
“UT
01” will appear, alternating with the message “OFF”. Now press once
on the button
n
and you will see the message “DAY 7”. You will
immediately note that the indicator light (9) of the display is on.
Figure 8 – Table of correspondence for days of
week
SET
TURBO
1
2
6
4
3
5
!
17°C
63°C
Display
(9)
Italiano
Deutsch Francais Espanol
LUN
MAR
MER
GIO
VEN
SAB
DOM
English
MON
DIE
MIT
DON
FRE
SAM
SON
LUN
MAR
MER
JEU
VEN
SAM
DIM
LUN
MAR
MIE
JUE
VIE
SAB
DOM
MON
TUE
WED
THR
FRI
SAT
SUN
~