MCZ Athos HYDRO 14 kW - Manual (Page 35)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page
35
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
SET
TURBO
1
2
6 4
3
5
!
16:
Ut 02
SET
TURBO
1
2
6 4
3
5
!
: 10
Ut 03
4.5. SETTINGS TO CARRY OUT BEFORE FIRST
LIGHTING
Set the main switch on the rear of the stove to position (I).
The display (8) of the control panel will show the message OFF and the
CURRENT TIME.
If the time shown is not correct, it can be reset by the procedure
described below.
You should keep in mind that the current time is only
needed when you carry out weekly programming
using the TIMER (see corresponding chapter). If the
time is not set correctly, this does not in any way
affect stove operation.
4.5.1. SETTING CURRENT TIME
In rapid sequence, press the buttons o and p to access technical
parameter UT01. If you again press the button p , you will access item
UT02, which shows the hours. Use the buttons n or o to decrease or
increase the hours.
To confirm the hour selected and move on to selection of the minute,
press key p . (you will see the item UT03)
Use keys n or o to decrease/increase the minute (steps of 1 minute).
To confirm the set time and exit, press r
4.6. SELECTION OF RECIPE
This is an exclusive MCZ evaluation criteria. It lets the user
identify the type of pellet to be used and as a result to provide
the stove with the most suitable settings. This prevent fuel
waste, ensures expected heating capability and protects the
condition of the product.
RECIPE SELECTION IS TO BE MADE
AT INITIAL INSTALLATION AND ANY
TIME THE TYPE OF PELLET IS
CHANGED.
(E.g. when you change supplier or when you notice differences in
colour or size of the pellets)
4.6.1. OPERATIONS FOR IDENTIFICATION OF THE
RECIPE:
• Identification of type of fuel
Sequence to access setting of hours and
minutes.
SET
TURBO
1
2
6 4
3
5
!
day 1
Ut 01
SWITCH