Epson EPL-N7000 - Manual (Page 336)

Troubleshooting 325
9
9
9
9
9
9
9
9
9
9
9
9
The computer is connected to
the network using AppleTalk
in a Windows NT 4.0/2000
environment, and the Send
CTRL+D Before Each Job or
Send CTRL+D After Each Job
setting on the Device Settings
sheet of the printer’s
Properties dialog box is set to
Yes. Make sure that both the Send CTRL+D
Before Each Job and Send CTRL+D
After Each Job settings are set to No.
The network connection is
something other than
AppleTalk, and the Data
Format setting is not set to
ASCII data. If the network connection is something
other than AppleTalk, make sure that
the Data Format setting is set to ASCII
data or Tagged binary communications
protocol.
The print data is too large. Click Advanced on the PostScript sheet
of the printer’s Properties dialog box,
and then change the Data Format setting
from ASCII data (default) to Tagged
binary communications protocol.
Printing cannot be performed
using the network interface. Click Advanced on the PostScript sheet
of the printer’s Properties dialog box,
and then change the Data Format setting
from ASCII data (default) to Tagged
binary communications protocol.