Epson EPL-N7000 - Manual (Page 111)

100 Using the PostScript Printer Driver (Windows)
4. The Add Printer Wizard will be displayed. Follow the
on-screen instructions until the screen asking you to select the
printer model is displayed.
5. Click Have Disk and specify the path to the appropriate INF
file necessary for installation. If your CD-ROM drive is D:, the
path will be D:\ADOBEPS\ENGLISH\WIN9X\PS_SETUP
(change the drive letter as needed for your system).
6. Select the INF file for the version of the Windows operating
system that you are running and continue with the
installation according to the on-screen instructions until the
screen asking you to select the port the printer is connected to
is displayed.
7. Select LPT1 as the port the printer is connected to, and then
click Next. Follow the on-screen instructions for the rest of the
installation.
8. When installation is done, click Finish.
Installing the PostScript printer driver for the USB interface
Follow these steps to install the PostScript printer driver for the
USB interface:
Note:
❏ The USB interface is not available for printing under Windows 95.
❏ If the Windows driver and the Adobe PS driver for an Epson printer
with a USB connection have already been installed on your
computer, follow the installation procedure explained in the
previous section, “Driver installation for the parallel interface
connection,” but make sure to select USB as the port in step 7. If
you have not installed an Epson USB printer driver on your
computer, follow the installation procedure below.
❏ You must have at least 6 MB of free space on your hard disk drive
to install the PostScript printer driver.