Emerson Process Management ControlWave EFM 3808 - Manual (Page 171)

CI-CW MICRO/CW EFM Appendix D - Radio/Modem Installation Guide / D-1
Appendix D
ECOM MODULE RADIO/MODEM
INSTALLATION GUIDE
D1.1 RADIO INSTALLATION & CONFIGURATION
D1.1.1 Installing an Internal FreeWave Radio (FGR09CSU)
FreeWave Radio Model GR09SCU is provided (for user installation) in a kit consisting of
the following components:
• 2-56 x .188” Pan Head Screw (Qty. 3) - Fig. D2 Reference = 1
• 2-56 x .250” F/F Standoff (Qty. 3) - Fig. D2 Reference = 2
• 2-56 x .250” Pan Head Screw (Qty. 3) - Fig. D2 Reference = 3
• FreeWave Radio Cable (with Nut and Washer) - Fig. D2 Reference = 4
• FreeWave Radio Module - Fig. D2 Reference = 5
To install a Model FGR09SCU Radio onto an Expansion Communication Module, perform
the following nine (9) steps:
1. Remove the Expansion Comm. Module from the unit in question (see Figure D1).
2. Grasp the Expansion Comm. Module with one hand. Squeeze both sides of the Cover
Panel (just below the unit’s top) and pull up and away to release the Cover Panel and
EMI Gasket from the PCB (see Figure D2).
Note: If necessary, a small screwdriver can
be used to pry the Cover Panel from the PCB.
3. Install the three (3), F/F Standoffs (item2) to the rear of the FreeWave Radio via three
(3), 2-56 x .250” Pan Head Screws (item 3) (through the PCB).
4. Mount the FreeWave Radio to the Exp. Comm. Module making sure that the interface
connectors (J12 on Exp. Comm. Module) align. Secure the FreeWave Radio to the Exp.
Comm. Module via three (3), 2-56 x .188” Pan Head Screws (item 1).
5. Plug the radio end of the Antenna Cable (item 4) into the FreeWave Radio’s RF
Connector.
6. If installing an optional MultiTech Model MT5634SMI Modem, proceed to Section D2.1
prior to installing the Antenna Cable to the Cover Panel; if not, install the antenna end
of the Antenna Cable (item 4) through the EMI Gasket and Cover Panel. Secure the
Antenna Cable to the Cover Panel via the Antenna Cable’s washer and nut.
7. Remove Expansion Comm. Module Jumper JP1 and place it in storage, i.e., plugged
onto pin 1 or 2.
8. Snap the Cover Panel onto the Expansion Comm. Module PCB and insert the ECOM
Module into the appropriate Backplane Slot, i.e., Slot 3 or 4.
9. Apply power and test the unit.