Yaskawa iQpump Programming Manual - Manual (Page 130)

130 YASKAWA TM.iQp.02 iQpump Drive Programming Manual
Figure 1.99
Figure 104 Sleep Function Based on Output Frequency
If P2-01 = “1: Output Current”
The iQpump drive can be configured to enter a “sleep” condition based on output current. The drive will enter the sleep mode when the
output current falls below the programmed Sleep Level (P2-02) for a time specified by the Sleep Delay Time (P2-03).
This function is only active during operation in the Auto Mode. The display will indicate “Sleep” alarm when active.
The Sleep Level Type works in conjunction with the Sleep Level (P2-02), Sleep Delay Time (P2-03), and Alternative Sleep Activate
Level (P2-20). A multi-function digital output can be programmed to enable sleep (H1-xx = 82).
TIME
Output Frequency
Sleep Delay Time
P2-03
Start Level Delay
P1-05
Feedback
Auto Mode Run
Sleep Active
Wait for Start
Sleep Level
P2-02
STOP, 0Hz
0%
OFF Mode
Start Level
P1-04
SLEEP ACTIVE
START DELAY
AUTO MODE RUN AUTO MODE STOP
Start System, Incoming Run Command
Start System
Min. Frequency
P1-06
AUTO MODE RUN
Start Level Delay
P1-05
START DELAY
System
Set-Point