Yaskawa GPD515/G5 - Manual (Page 34)

9 Appendix 1 Ratings
34 YASKAWA PL.A1000.01 G5 to A1000 - Product Transition Guide
„ Braking Resistor Installation Attachment
The G5 allows a braking resistor to be installed directly to the unit on the backside (heatsink). The A1000 requires a
special attachment for installation. The table below lists the attachment sizes according to the drive capacity.
The attachment will increase the overall size of the drive when installing a braking resistor to certain A1000 models.
Figure 20
Figure 20 Installing a Braking Resistor on A1000 (240 V class 0.4 kW, or 0.5 HP)
Table 21 A1000 Dimensions after Installing Resistor Attachment
Note: Use of the braking resistor attachment may void certain vibration and shock requirements, particularly when installed in
combination with other attachments for retrofitting A1000 to the GPD515/G5 installation. For areas where vibration is a major
concern, install the braking resistor directly to a seperate panel board instead of using the resistor attachment.
Voltage
Class
Capacity
(HP)
Dimensions (in)
D1, D2, D3
Differences
(in)
Attachment for
Braking Resistor
Model
(Parts Code)
G5 A1000
W H D1 D2 D W H D1 D2 D3 D
3-Phase
200 V
Class
0.75
5.51 11.02 4.76
1.54 6.30
5.51 10.23 4.29
1.5
1.10
6.89
+0.59
EZZ020805A
(100-048-123)
1 +0.59
2 +0.59
3
2.32 7.08
+0.19
5 2.17 7.56 +0.48
3-Phase
400 V
Class
0.75
5.51 11.02 4.76
1.54 6.30
5.51 10.23 4.29
1.5
1.10
6.89
+0.59
1 +0.59
2 +0.59
3
2.32 7.08 2.17 7.56
+0.19
5 +0.48
3-Phase
600 V
Class
0.75
5.51 11.02 4.76
1.54 6.30
5.51 10.23 4.29
1.5
1.10
6.89
+0.59
Contact Factory
1 +0.59
2
2.32 7.08
+0.59
3
2.17 7.56
+0.19
5 +0.48
+
:
'
'
'
'