HEIDENHAIN PWM 20 - Manual (Page 33)

34 HEIDENHAIN ATS Software User's Manual
5.2.2 Automatic encoder identification by entering the ID
1 Input field for ID
2 The encoder was identified.
3 Input field for the "feed-through mode" (measurement in control loop of machine axis)
Note
Use the ID of the scale housing for sealed linear encoders (e.g. LC), and the ID of the
scanning head for exposed linear and angle encoders (e.g. LIC).
The ID can also be entered without the hyphen (e.g. 36856306).
If the encoder cannot be identified, the software enters three question marks "???".
(See chapter “Manual encoder selection” on page 37.)