HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 98)

98
Definin
g
Mac
hin
ing Oper
ation
s
Additional parameters on the stud parameters detail form:
U Allowance for side : Finishing allowance for the side
U Angle of rotation : Angle by which the entire stud is rotated
U Stud position : Position of the stud referenced to the programmed
position
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd set-up clearance
U Overlap factor
U Feed rate for traversing between machining positions
U Climb milling, or
U Up-cut milling