HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 223)

223
Gr
aph
ically T
e
sting and
Runnin
g
a Unit Pr
ogr
am
Running a unit program
You can run a unit program in the Program Run submode in the following
ways:
„ Run the unit program unit by unit
„ Run the entire unit program
„ Run individual, active units
You can run UNIT programs (*.HU) in the smarT.NC
operating mode, or in the usual Program Run, Single Block or
Program Run, Full Sequence operating modes.
When the “smarT.NC: Program run” operating mode is
selected, the TNC automatically deactivates all global
program-run settings that you have activated in the
conventional Single Block or Full Sequence program run
modes. Refer to the Conversational Programming User's
Manual for more information about this.
Please note the instructions on running a program in the
machine manual and the User's Manual.