HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 107)

107
Definin
g
Mac
hin
ing Oper
ation
s
Additional parameters on the contour detail form:
U Depth : Separately definable depths for each subcontour (FCL 2
function)
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd set-up clearance
U Overlap factor
U Retraction feed rate
U Climb milling, or
U Up-cut milling
„ Always start the list of subcontours with the deepest
pocket!
„ If the contour is defined as an island, the TNC interprets the
entered depth as the island height. The entered value
(without an algebraic sign) then refers to the workpiece top
surface!
„ If the depth is entered as 0, then for pockets the depth
defined in the overview form is effective. Islands then rise
up to the workpiece top surface!