HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 114)

114
Definin
g
Mac
hin
ing Oper
ation
s
U Center angle (Only in effect if tangential approach on a circular path
was selected): Angle of the circular arc
U Distance to aux. point (Only in effect if tangential approach on a
straight path or vertical approach was selected): Distance to the
auxiliary point from which the contour is approached
U Contour name : Name of the contour file (.HC) to be machined. If the
DXF converter option is available, you can use it to make a contour
directly from the form.