HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 80)

80
Definin
g
Mac
hin
ing Oper
ation
s
Unit 263 Thread Milling / Countersinking
Parameters on the overview form:
U T : Tool number or name (switchable via soft key)
U S : Spindle speed [rpm] or cutting speed [m/min or ipm]
U F : Feed rate for milling
U F : Countersinking feed rate [mm/min] or FU [mm/rev]
U Diameter : Nominal diameter of the thread
U Thread pitch : Pitch of the thread
U Depth : Depth of the thread
U Countersinking depth : Distance between the top surface of the
workpiece and the tool tip during countersinking
U Clearance to side : Distance between tool tooth and the wall
U Machining positions (see “Defining Machining Positions” on page
157.)
Additional parameters on the tool detail form:
U DL : Delta length for tool T
U DR : Delta radius for tool T
U M function : Any miscellaneous function M
U Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)