HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 92)

92
Definin
g
Mac
hin
ing Oper
ation
s
Additional parameters on the pocket parameters detail form:
U Allowance for side : Finishing allowance for the side
U Allowance in depth : Finishing allowance for the depth
U Infeed for finishing : Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed
U F rate for finishing : Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd set-up clearance
U Overlap factor
U Feed rate for traversing between machining positions
U Climb milling, or
U Up-cut milling
U Plunge in a helical motion, or
U Plunge vertically