HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 42)

42
F
unda
mentals
Copying units
You can copy individual machining units very easily with the familiar
Windows shortcut keys:
„ Ctrl+C to copy the unit
„ Ctrl+X to cut the unit out
„ Ctrl+V to insert the unit behind the active one
If you want to copy two or more units at the same time, proceed as
follows:
U Switch to the top level of the soft-key row
U Use the arrow keys or the mouse to select the first unit to be
copied
U Activate the marking function
U Use the cursor keys or the MARK NEXT BLOCK soft key to
select all units to be copied
U Copy the marked block to the clipboard (also works with
Ctrl+C)
U Use the cursor keys or soft key to select the unit just before
the desired insertion point for the copied block
U Insert the block from the clipboard (also works with Ctrl+V)