HEIDENHAIN 530 (340 49x-07) Pilot User Manual
Page 166
166
Definin
g
Mac
hin
ing P
o
sitions
Starting the pattern generator from a form
U
Select the smarT.NC operating mode
U
Select any machining step in which machining positions can
be defined
U
Select an input field in which a machining position is to be
defined (see figure at top right)
U
Switch to Define machining positions in point table
U
To create a new file: Enter the file name (without file type),
and confirm with the NEW .HP soft key
U
Specify the units of measurement for the new point file with
the MM or INCH button in the pop-up window. smarT.NC
then starts the pattern generator
U
To select an existing HP file: Press the SELECT .HP soft
key. smarT.NC opens a pop-up window with available point
files. Select one of the displayed files, and open it with the
ENT key or OK screen button.
U
To edit an existing HP file: Press the EDIT .HP soft key.
smarT.NC starts the pattern generator
U
To select an existing PNT file: Press the SELECT .PNT soft
key. smarT.NC opens a pop-up window with available point
files. Select one of the displayed files, and open it with the
ENT key or OK screen button.
If you want to edit a .PNT file, smarT.NC converts it to an .HP
file! Answer the dialog prompt with OK.