HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 39)

39
F
unda
mentals
Editing contours
1 1 2
1 3
1 4
1 4.1 1 4.2 1 4.3
1 5
1 6
1 Header: Operating mode text, error messages
2 Active background mode of operation
3 Tree view in which the contour elements are shown in a structured
format
4 Form window with the various input parameters. In FK programming
there can be up to four forms:
„ 4.1 : Overview form
Contains the input possibilities used most often
„ 4.2 : Detail form 1
Contains input possibilities for auxiliary points (FL/FLT) and for
circle data (FC/FCT)
„ 4.3 : Detail form 2
Contains input possibilities for relative references (FL/FLT) and for
auxiliary points (FC/FCT)
„ 4.4 : Detail form 3
Only available for FC/FCT, contains input possibilities for relative
references
5 Support graphics window, in which the input parameter currently
active is displayed
6 Graphics window, in which the programmed contours are shown
immediately after the form is saved