HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 220)

220
Gr
aph
ically T
e
sting and
Runnin
g
a Unit Pr
ogr
am
Test graphics and program-run graphics
The TNC can graphically display a machining operation in the Test Run
and Program Run submodes of operation. The following functions are
available via soft key:
U Plan view
U Projection in three planes
U 3-D view
U Run a program test up to a certain block
U Test the entire program
U Test the program unit-by-unit
U Reset the blank form and test the entire program
U Display / Do not display workpiece blank outline
U Reset workpiece blank
U Display or hide tool
Select the GRAPHICS or PROGRAM+GRAPHICS layout.