HEIDENHAIN 530 (340 49x-07) Pilot - Manual (Page 59)

59
Definin
g
Mac
hin
ing Oper
ation
s
Machining main group
In the Machining main group you select the following machining groups:
Machining group Soft key Page
DRILLING
Centering, drilling, reaming, boring, back
boring Page 60
THREAD
Tapping with floating tap holder, rigid
tapping, thread milling Page 73
POCKETS/STUDS
Bore milling, rectangular pockets, circular
pockets, slots, circular slots Page 88
CONTR. PGM
Run contour programs: contour train,
contour pocket roughing, fine roughing
and finishing Page 103
SURFACES
Face milling Page 125
SPECIAL UNITS:
Engraving and interpolation turning Page 129