HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 9)

HEIDENHAIN iTNC 530 9
Location of use
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information:
This product uses open source software. Further information is
available on the control under
8 Programming and Editing operating mode
8 MOD function
8 LEGAL INFORMATION soft key
Filtering of externally created contours Conversational
Programming User’s
Manual
Possibility of assigning different depths
to each subcontour in the contour
formula Conversational
Programming User’s
Manual
DHCP dynamic IP-address
management Page 603
Touch-probe cycle for global setting of
touch-probe parameters Touch Probe Cycles
User’s Manual
smarT.NC: Graphic support of block
scan smarT.NC Pilot
smarT.NC: Coordinate transformation smarT.NC Pilot
smarT.NC: PLANE function smarT.NC Pilot
FCL 2 functions Description