HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 639)

HEIDENHAIN iTNC 530 639
14.1 Gener
a
l User P
a
ra
met
e
rs
Reset status display, Q
parameters, tool data
and machining time MP7300
Reset all when a program is selected: 0
Reset all when a program is selected and with M02, M30, END PGM (with PGM CALL: END
PGM of the highest calling program): 1
Reset only status display and tool data when a program is selected: 2
Reset only status display, machining time and tool data when a program is selected and at M02,
M30, END PGM (with PGM CALL: END PGM of the highest calling program): 3
Reset status display, machining time and Q parameters when a program is selected: 4
Reset only status display, machining time and Q parameters when a program is selected and at
M02, M30, END PGM (with PGM CALL: END PGM of the highest calling program): 5
Reset status display and machining time when a program is selected: 6
Reset only status display and machining time when a program is selected and at M02, M30, END
PGM (with PGM CALL: END PGM of the highest calling program): 7
Graphic display mode MP7310
Projection in three planes according to ISO 6433, projection method 1: +1
Projection in three planes according to ISO 6433, projection method 2: +1
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the old datum: +0
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the new datum: +4
Do not show cursor position during projection in three planes: +0
Show cursor position during projection in three planes: +8
Software functions of the new 3-D graphics active: +0
Software functions of the new 3-D graphics inactive: +16
Limitation of a tool’s
tooth length to be
simulated. Only
effective if LCUTS is
not defined. MP7312
0 to 99 999.9999 [mm]
Factor by which the tool diameter is multiplied in order to increase the simulation speed. If 0 is
entered, the TNC assumes an infinitely long tooth length, which increases the simulation speed.
Graphic simulation
without programmed
tool axis: Tool radius MP7315
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: Penetration
depth MP7316
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: M-function
for start MP7317.0
0 to 88 (0: Function inactive)
Graphic simulation
without programmed
tool axis: M function
for end MP7317.1
0 to 88 (0: Function inactive)
Screen saver MP7392.0
0 to 99 [min]
Time in minutes until the screen saver switches on (0: Function not active)
MP7392.1
No screen saver is active: 0
Standard screen saver of the X server: 1
3-D line pattern: 2
TNC displays, TNC editor