HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 591)

HEIDENHAIN iTNC 530 591
12.9 A
d
aptiv
e F
eed Contr
o
l Sof
tw
a
re
Option (AFC)
Log file
In a teach-in cut, the TNC saves for each machining step relevant data
in the .I.AFC2.DEP file. is for the name of the NC
program for which you have recorded the teach-in cut. During control,
the TNC updates the data and makes various evaluations. The
following data are to be saved in this table:
Column Function
NR Number of the machining step
TOOL Number or name of the tool with which the machining
step was made
IDX Index of the tool with which the machining step was
made
SNOM Nominal spindle speed [rpm]
SDIF Maximum difference of the spindle speed in % from
the nominal speed
LTIME Machining time for the teach-in cut
CTIME Machining time for the control cut
TDIFF Time difference in % between the machining time
during teach-in and control
PMAX Maximum recorded spindle power during machining.
The TNC displays the value in percent with respect to
the rated power of the spindle.
PREF Reference load of the spindle. The TNC displays the
value in percent with respect to the rated power of the
spindle.
OVLD Reaction made by the TNC to overload:
„
M : A macro defined by the machine tool builder has
been run
„
S : Immediate NC stop was conducted
„
F : NC stop was conducted after the tool was been
retracted
„ E : An error message was displayed
„ - : There was no overload reaction
BLOCK Block number at which the machining step begins
The TNC records the total machining time for all teach-in
cuts (LTIME), all control cuts (CTIME) and the total time
difference (TDIFF), and enters it after the keyword TOTAL
in the last line of the log file.