HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 576)

576 12 Test Run and Program Run
12.8 Global Pr
ogr
a
m Set
tings (Sof
tw
ar
e Option)
12.8 Global Program Settings
(Software Option)
Function
The global program settings, which are used in particular for large
molds and dies, are available in the Program Run mode and MDI
mode. You can use it to define various coordinate transformations and
settings that are globally effective and are superimposed on the
respectively selected NC program so that you do not need to edit the
NC program.
You can activate and deactivate global program settings, even in mid-
program if you have interrupted the program run (see “Interrupting
machining” on page 564).
The following global program settings are available:
Function Icon Page
Exchanging axes Page 579
Basic rotation Page 579
Additional, additive datum shift Page 580
Superimposed mirroring Page 580
Superimposed rotation Page 581
Axis locking Page 581
Definition of a handwheel
superimposition Page 582
Definition of a globally effective feed rate
factor Page 581