beautypg.com

6 optional block skip, Function, Erasing the “/” character – HEIDENHAIN iTNC 530 (340 49x-03) ISO programming User Manual

Page 574: 6 op tion al bloc k skip 12.6 optional block skip

background image

574

12 Test Run and Program Run

12.6 Op

tion

al Bloc

k Skip

12.6 Optional Block Skip

Function

In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:

8

To run or test the program without the blocks

preceded by a slash, set the soft key to ON.

8

To run or test the program with the blocks preceded

by a slash, set the soft key to OFF.

Erasing the “/” character

8

In the Programming and Editing mode you select the block in which
the character is to be erased.

8

Erase the “/” character.

This function does not work for G99 blocks.

After a power interruption the control returns to the most
recently selected setting.

See also other documents in the category HEIDENHAIN Equipment: