HEIDENHAIN iTNC 530 (340 49x-03) ISO programming - Manual (Page 480)

480 9 Programming: Special Functions
9.8 Tilting the w
o
rking plane
thr
o
ugh axis angle: PLANE
A
XIAL
(F
C
L3f
u
n
c
ti
o
n
) 9.8 Tilting the working plane
through axis angle:
PLANE AXIAL (FCL 3 function)
Function
The PLANE AXIAL function defines both the position of the working
plane and the nominal coordinates of the rotary axes. This function is
particularly easy to use on machines with Cartesian coordinates and
with kinematic structures in which only one rotary axis is active.
The PLANE AXIAL can also be used if you have only one
rotary axis active on your machine
You can use the PLANE RELATIV function after PLANE AXIAL
if your machine allows spatial angle definitions. The
machine tool manual provides further information.
Before programming, note the following:
Enter only axis angles that actually exist on your machine.
Otherwise the TNC generates an error message.
Rotary axis coordinates defined with PLANE AXIAL are
modally effective. Successive definitions therefore build
on each other. Incremental input is allowed.
To reset the PLANE AXIS function, use PLANE RESET.
Resetting by entering 0 does not deactivate PLANE AXIAL.
SEQ, TABLE ROT and COORD ROT have no function in
conjunction with PLANE AXIS.
Parameter description for the positioning behavior: See
“Specifying the Positioning Behavior of the PLANE
Function,” page 482.