Polaris Series 10 Ranger 425 2x4 - Manual (Page 97)

95
MAINTENANCE AND LUBRICATION
Brakes
Front and Rear Brakes
The front and rear brakes are
hydraulic disc type brakes activated
by the brake pedal. See page 53.
The following checks are
recommended to keep the brake
system in good operating condition.
How often they need checking
depends upon the type of driving that
has been done.
S
Inspect the level of the brake fluid
before each operation. Change
the brake fluid according to the
Periodic Maintenance Chart. The brake fluid should also be
changed if it becomes contaminated with dirt or water.
S
To check the fluid level, the vehicle must be on level ground. In-
spect the brake fluid by looking at the reservoir (1) under the hood.
The level should be between the upper (MAX) and lower (MIN)
level lines.
S
If the fluid level is lower than the lower level line, add brake fluid
to the upper (MAX) line. Apply the brake forcefully for a few sec-
onds and check for fluid leakage around the fittings.
Polaris does not recommend the use of a high pressure wash system to
clean your RANGER. The best and safest way to clean your vehicle is
with a garden hose and a pail of mild soap and water. Use a
professional type washing mitten, cleaning the upper body first and the
lower parts last. Rinse with water frequently and dry with a chamois to
prevent water spots. NOTE: If warning labels are damaged, contact
your a Polaris dealer for free replacement.
1
CAUTION
Change the fluid in the brake system completely if the fluid level is
low or the type and brand of the fluid already in the reservoir are
unknown.
Once a bottle of brake fluid is opened, use what is necessary and
discard the rest. Do not store or use a partial bottle of brake fluid.
Brake fluid is hygroscopic, meaning it rapidly absorbs moisture
from the air. This causes the boiling temperature of the brake fluid
to drop, which can lead to early brake fade and the possibility of
serious injury.