Polaris Series 10 Ranger 425 2x4 - Manual (Page 84)

82
MAINTENANCE AND LUBRICATION
Engine Cooling System
Coolant Level Inspection
NOTE: Check the coolant
level when the engine is cold
(room or atmospheric
temperature).
1. Situate the vehicle on
level ground.
2. Check the coolant level
by looking at the
overflow bottle located in
front of the right front
wheel. The coolant level
should be between the
Minimum and Maximum
marks.
3. If the amount of coolant
is not within the operating
range lift the hood, and locate the overflow bottle lid. Unscrew the
lid from the overflow bottle and use a funnel to add coolant
through the filler opening until the fluid level has reached the
maximum mark. Install the cap.
NOTE: Polaris recommends the use of Polaris Premium 60/40
anti-freeze/coolant or a 50/50 mixture of high quality aluminum
compatible anti-freeze/coolant and distilled water. NOTE: Polaris
Premium 60/40 is already premixed and ready to use. Do not dilute
with water. NOTE: Always follow the manufacturer’s mixing
recommendations for the freeze protection required in your area.
NOTE: In an emergency you can add water alone to the overflow
bottle, however it must be returned to the correct mixture ratio by the
addition of antifreeze concentrate as soon as possible.
CAUTION
If coolant must be added often, or the overflow bottle completely
runs dry, it is possible there is a leak in the system. Have the
cooling system inspected by your Polaris RANGER dealer.