Polaris Series 10 Ranger 425 2x4 - Manual (Page 112)

110
MAINTENANCE AND LUBRICATION
Battery
Battery Installation
1. Set the battery in its holder.
2. Install the battery vent tube. It must be free from obstructions and
securely installed. If not, battery gases could accumulate and cause
an explosion. The tube should be routed away from the frame and
body to prevent corrosion. Avoid skin contact with electrolyte,
severe burns could result.
3. First connect and tighten the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Verify that cables are properly routed.
NOTE:
S
When your RANGER is placed in storage for three months or more,
the battery should be removed, charged to proper level, and stored
in a cool dry place.
S
Before reusing, take the battery to your dealer for testing and re-
charging.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to
the RANGER.
To avoid the possibility of explosion, always connect battery
cables in the order specified. Red (positive) cable first; black
(negative) cable last.
WARNING