Polaris Series 10 Ranger 425 2x4 - Manual (Page 78)

76
MAINTENANCE AND LUBRICATION
Engine Oil
Oil and Filter Change (cont.)
8. Disconnect the lower
oil delivery hose.
Remove the fitting (C)
from the oil tank.
Clean the fitting
screen. Reinstall the
fitting screen, torquing
to 14-17 ft. lbs.
Reattach oil line.
Torque banjo fitting
(D) to 14-17 ft. lbs.
9. Place shop towels
beneath oil filter.
Using an oil filter
wrench, turn filter (1)
counterclockwise to
remove.
10. Using a clean dry
cloth, clean filter
sealing surface on
crankcase.
11. Lubricate O-Ring on
new filter with a film
of new engine oil.
Check to make sure the
O-Ring is in good
condition. Also make
sure the O-ring from
the old filter is not still
on the engine.
12. Install new filter (1) and tighten by hand 1/2 to 3/4 turn after
gasket contact.
13. Approximately 1 cup of engine oil will remain in the crankcase.
To drain, remove drain plug found on lower right side of
crankcase. NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks or scratches.
A
B
C
D
1