Grass Valley Network Attached Storage System Serial ATA Network User Guide v.1.0.06 - Manual (Page 31)

Chapter 2 Software Setup
30 Digital News Production
Configuring Network Ports
Configure network ports to work in your environment. Do not enable jumbo
frames unless you are certain your software allows for it. For more detailed
information, refer to “Configuring Network Ports” on page 52.
1. Enter a public IP address for Port 0 (external). This is the appliance address
on the network.
2. Enter a network netmask.
3. Click Next to continue.
Entering a Name and IP Address
For more detailed information, refer to “Changing Names and IPs” on page 53.
1. Enter a local domain name. The default is Default.Domain.
2. Enter a gateway address. The default gateway address is 0.0.0.0 (no
gateway).
3. Enter a node name for the appliance.
4. Click Next to continue.
Changing the Password
For more detailed information, refer to “Changing Passwords” on page 82.
1. Change the appliance password, if necessary. (Remember to write it down.)
2. Click Next to continue.
Setting the Date and Time
For more detailed information, refer to “Setting Date and Time” on page 86.
1. Select the correct time zone, date, and time for your area.
2. Click Next to continue.