Or the, 8943rda-dfr status web – Grass Valley 8943RDA User Manual
Page 63
Use
this
link
8943RDA/-D/-DFR — Instruction Manual
63
Configuration
8943RDA-DFR Status Web Page
The Status web page for the 8943RDA-DFR shows the signal status of the
input signal(s) and communication status with the frame bus. Color coding
of the display indicates the signal status.
In general, graphics and text colors used indicate the following:
•
Green = Pass – signal or reference present, no problems detected.
•
Red = Fault – fault condition.
•
Yellow = Warning – signal is absent, has errors, or is mis-configured.
•
Gray = Not monitored.
The graphic shows the input and output signals available for the module.
Only input signal status is reported by color in this graphic. Outputs are not
monitored (always gray). The input signal status reporting to the module
level can be disabled on the I/O Config web page.
The Status LED on each web page will display the collective status of the
module. Refer to
Collective Module Status Reporting on page 27
.
Also shown is the rear and front module status. Information about the
module, such as Part Number, Serial Number, Hardware Revision, Soft-
ware Version, and Asset Tag number (assigned on the Slot Config web
page) are given in table format at the bottom of the Status web page.
The area inside the double bars below the graphic will report warning mes-
sages from the module.
Also shown is the rear and front module status and the status of any
optional SFP fiber optic submodules installed. A list of available 3G SFP
fiber optic submodules is given in
.
The Status web pages for the 8943RDA-DFR with each of the different types
of submodule are shown in the following figures:
•
8943RDA-DFR without SFP fiber optic submodule option (
•
8943RDA-DFR with Dual Transmitter fiber submodule (
•
8943RDA-DFR with Dual Receiver fiber submodule (
•
8943RDA-DFR with Transceiver fiber submodule (
)