Tatus – Grass Valley 8943RDA User Manual
Page 54
Use
this
link
54
8943RDA/-D/-DFR — Instruction Manual
Configuration
8943RDA-D Status Web Page
The Status web page (
) for the 8943RDA-D shows the
signal status of the input signal(s) and communication status with the
frame bus. Color coding of the display indicates the signal status.
In general, graphics and text colors used indicate the following:
•
Green = Pass – signal or reference present, no problems detected.
•
Red = Fault – fault condition.
•
Yellow = Warning – signal is absent, has errors, or is mis-configured.
•
Gray = Not monitored.
Under the
Status
title are given the model description, the Frame location,
and the slot location of the module in the frame.
The graphic shows the input and output signals available for the module.
Only input signal status is reported by color in this graphic. Outputs are not
monitored (always gray). The input signal status reporting to the module
level can be disabled on the I/O Config web page.
The Status LED on each web page and the module status in the frame
graphic on the Status web page will display the collective status of the
module. Refer to
Collective Module Status Reporting on page 27
.
Also shown is the rear and front module status. Information about the
module, such as Part Number, Serial Number, Hardware Revision, Soft-
ware Version, and Asset Tag number (assigned on the Slot Config web
page) are given in table format at the bottom of the Status web page.
The area inside the double bars below the graphic will report warning mes-
sages from the module.
Note
The 8943RDA-D module software version can be either 1.0.4 or 1.1.0. The
difference in software versions only affects the 8943RDA-DFR fiber optic
submodule.