Grass Valley 8943RDA - Manual (Page 26)

26 8943RDA/-D/-DFR — Instruction Manual
Power Up
Refer to Table 5 for a description of each front edge LED and how it oper-
ates. LEDs present on specific module are illustrated in the figures listed
below.
Note Some LEDs, such as the FAULT LED, must report a collective state for all four
channels. This collective state is outlined in
Table 6 on page 27 .
• 8943RDA ( Figure 19 on page 42 )
• 8943RDA-D ( Figure 24 on page 52 )
• 8943RDA-DFR ( Figure 28 on page 61 )
Table 5. Front Edge LED Indicators
LED Indication Condition
STATUS LEDS
FAULT
(red)
Off Collective module state of pass
On continuously Collective state of internal fault
Flashing Collective state of warning
COMM
(yellow)
Off No activity on frame communication bus
Double flash Location Command received by the module from a remote control system
Continuous short flash Activity present on the frame communication bus
CONFIG
(yellow)
Off No configuration change is in process, initialization complete
On Module is initializing or changing operating modes
Double flash
In unison with COMM LED, Location Command received by the module from a remote
control system
PWR
(green)
Off No power to module or module’s DC/DC converter failed
On continuously Normal operation, module is powered
CH 1-4 PRESENT
(Green)
Off No carrier
On Continuously Energized signal present
CH 1-4 3G
(Blue)
Off Signal present on CH 1-4 input is not detected as 3 Gb/s (carrier is way off frequency)
Flashing Occurs when the mode is set to manual bypass
On Continuously Signal present on CH 1-4 input is detected as 3 Gb/s
CH 1-4 HD
(Yellow)
Off
Signal present on CH 1-4 input is not detected as 1.485 Gb/s (carrier is way off fre-
quency)
Flashing Occurs when the mode is set to manual bypass
On Continuously Signal present on CH 1-4 input is detected as 1.485 Gb/s
CH 1-4 SD
(Yellow)
Off Signal present on CH 1-4 input is not 1.485 (carrier is way off in frequency)
Flashing Occurs when the mode is set to manual bypass
On Continuously Signal present on CH 1-4 input is detected as 270 Mb/s
OPT MOD_1
(Yellow)
(8943RDA-DFR only)
Off
No SFP fiber optic submodule is installed or the SFP installed in the first SFP position
has a fault as noted on Status web page
On Continuously
A supported SFP submodule is installed in the top SFP position (see Table 1 on page 14 )
for supported types)
Flashing An unsupported SFP submodule is installed in the top SFP position
OPT MOD_2
(Yellow)
Off
Not used in this version
On