Grass Valley 8943RDA - Manual (Page 17)

8943RDA/-D/-DFR — Instruction Manual 17
Installation
4. Once the submodule is seated into the SCA-2 connector and the straps
are completely under the screws, tighten the screws to hold the
submodule in place.
Installing Fiber Jumper Cable Assembly
Before installing the fiber jumper cable assembly ( Figure 8 ), remove the
protective ferrule covers and clean all fiber optic surfaces on the duplex and
simplex ferrule ends of the 2-channel fiber jumper cable assembly and the
submodule connector.
Use a standard fiber optic cleaning kit as described in Fiber Optic Cleaning
Requirement on page 21 .
Figure 8. 2-Channel Fiber Jumper Cable Assembly
Ferrule covers
Duplex end
Simplex ends