Grass Valley 8943RDA - Manual (Page 19)

8943RDA/-D/-DFR — Instruction Manual 19
Installation
Front Module Installation
After installing the rear module and the fiber optic submodule option if
being used, install the front module as follows:
1. On the top of the front module, locate the LOC and LOC/REM jumper,
J10, shown in
Figure 19 on page 42 .
2. Set jumper J10 to LOC (pins 1-2) to lock out remote control, or
LOC/REM (pins 2-3), the default, for both local and remote control.
3. For 8943RDA-DFR modules using Dual Transmitter or Transceiver
fiber optic submodules: If you have installed an optional dual fiber
transmitter or transceiver submodule on your 8943RDA-DFR front
module, you must enable the transmitter output(s) by setting jumper,
J13 on the circuit board to pins 1-2, as shown in
Figure 15 on page 33 .
4. Locate the front slot corresponding to the rear module already
installed.
5. Insert the front module so that the circuit board slides through the
guides on the right side the slot (
Figure 10 on page 20 ).
6. Carefully slide the module into the rear connector, making sure the
fiber optic connector fits into the rear module properly.
7. Lock the front module ejector tab into the locking pin.
8. Replace the frame front cover during operation to maintain optimum
cooling conditions.