Grass Valley 8943RDA - Manual (Page 35)

8943RDA/-D/-DFR — Instruction Manual 35
Configuration
Set INPUT OP MODE
To set the INPUT OP MODE for each available channel, do the following:
1. CH1 OP MODE ( all models): Using a small flat blade screwdriver or an
adjustment tool, move the FUNCTION rotary switch to position 1 . As
shown in Table 9 on page 34 , this is the position for setting the INPUT
OP MODE for CH1.
Use the paddle switch, S2, to move up and down through the following
available INPUT OP MODE choices:
• AUTO BYP
• AUTO RC
• 3G
• HD
• SD
• BYPASS
Each of these choices is described in detail in Input Operating Modes on
page 28 . As the paddle switch is pressed, the corresponding INPUT OP
MODE yellow LED will light on the LED array, indicating which mode
is currently selected. Stop on the LED corresponding to the mode you
want.
2. CH2 OP MODE ( 8943RDA-D and 8943RDA-DFR) Set the Function rotary
switch to 2 to select the CH2 OP MODE. Use the paddle switch, S2, to
scroll through to one of the choices listed in Step 1 above.
3. CH3 OP MODE ( 8943RDA-DFR) Set the Function rotary switch to 3 to select
the CH3 OP MODE. Use the paddle switch, S2, to scroll through to one
of the choices listed in Step 1 above.
4. CH4 OP MODE ( 8943RDA-DFR) Set the Function rotary switch to 4 to select
the CH4 OP MODE. Use the paddle switch, S2, to scroll through to one
of the choices listed in Step 1 above.